home *** CD-ROM | disk | FTP | other *** search
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
- % %
- % "BOMB TRAPS" %
- % AND %
- % DESTRUCTION %
- % IN %
- % GENRAL %
- % %
- % WRITTEN BY THE DISASTER MASTER %
- % %
- % A BROTHERS OF THE EYE PRESENTATION (B.O.T.E.) %
- % %
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
- Well in this file we will discuss different ways of making traps. And we
- will also talk about some different kinds detonators.
-
- DISCLAIMER----NEITHER I NOR ANY MEMBER OF MY GROUP BE HELD RESPONSIBLE FOR ANY
- DAMAGE,CHAOS OR DESTRUCTION DONE BY ANY INFORMATION IN THIS FILE IT IS FOR
- INFORMATION PURPOSES ONLY (SURE).
-
- ITEMS WE WILL DISCUSS
- ---------------------
- 1.ROAD TRAP
- 2.WALK TRAP
- 3.BOOK TRAP
- 4.DOOR-HANDLE TRAPS
- 5.LOOSE FLOORBOARD TRAP
- 6.ASSORTED DETONATORS
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
- THE ROAD TRAP
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
-
- The first trap I will discuss is a basic road trap. You need a wire-trap
- action to complete the electrical circuit. It is extremely simple to make,
- since all the equipment can be gathered in or around your house. The great
- advantage to this is that it will explode when the car is directly over it. So
- insuring maximum destruction.
-
- DIAGRAM 1
-
- ############### ##################
- ################ #####################
- ################ #####################
- ############# ###################
- ######## #############
- ###### ######
- ###### ######
- #####-TREES ######
- #####----------------------------ROPE---------------------------->>-_-_-######
- _____________________________________ROAD__________________WEDGE_||___________
- ______________________________________________________CLOTHES PIN_|___________
- ___UNDER THE ROAD____CHARGE_______________________CHARGE___________BATTERY____
-
- CLOSE UP OF CLOTHES PIN AND WEDGE
-
- --------\ +-------WIRE----------------------
- ---------\ =-----\
- ---ROPE--------------/ \
- -------/ /
- =-----/
- +-------OTHER WIRE----------------
-
- To construct the road trap start by digging three holes across the road. In
- two of the holes place the explosive charges, and in the third place a regular
- car battery. Connect the first wire from the negative terminal of the battery
- via each of the blasting caps, in each charge, to a metal pin on one side of
- an ordinary clothes pin. The second wire should be directly connected from the
- positive terminal on the battery to the opposite metal pin on the same clothes
- pin. The clothes pin must be kept open by a small wooden wedge, which is
- attached to a thin black wire (rope) stretched across the road. When the semi-
- invisible wire is pulled the wedge will be pulled out of the clothes pin thus
- closing the clothes pin. When the clothes pin is closed the two metal pins
- will connect and complete the electrical circuit, thus exploding the charges.
-
- ##############################################################################
- WALK TRAP
- ##############################################################################
-
- This incorporates the same type of wire-trap action as in the road trap.
- The walk trap is not electrically operated, it relies on a percussion
- detonator. When the wire is pilled it pulls the safety pin out of the heavy
- firing pin. The heat created by the detonators explosion will be sufficient
- to set off the tnt. This type of trap is especially good for dense forest
- area, where the wire cannot be seen.
-
- CLOSEUP OF BOMB
- #######################################GROUND#################################
- # ##### #
- #-----#####-----#------PIN
- # ### #
- # # #
- # #
- # ( ) # <-DETONATOR
- #%%%%%%%%%%%%%%%#
- #%%%%%%TNT%%%%%%#
- #%%%%%%%%%%%%%%%#
- #################
- ##############################################################################
- BOOK TRAP
- ##############################################################################
-
- To construct this you will need a large book, perhaps about a thousand
- pages. The book should be hollowed out, leaving the edges intact. In the
- hollow place, put a dry cell and your explosive,and connect the wires. Fix two
- metal contact points to the edges of the book, and seperate them with a wooden
- wedge, which is attached to the rear wall of the bookcase. This must be
- acomplished in such a manner that, when the book is removed from the shelf the
- two metal contact points will touch and complete the electrical circuit, thus
- causing the detonation of the explosive charge.
-
- CLOSE UP OF BOOK TRAP
-
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%% %%
- %% %%%%%%%%%-----------------------------= %% <-METAL CONTACT
- %% EXPLOSIVE %%%%%%% <-WOODEN WEDGE
- %% %%%%%%%%%--------BATTERY--------------= %% <-METAL CONTACT
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%% %%
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
- ##############################################################################
- DOOR HANDLE TRAPS
- ##############################################################################
-
- There are two basic methods of booby-trapping door handles the first employs
- a short test tube, a cork, two needles, three wires, one electrical blasting
- cap, one metal ball bearing, and one stick of dynamite. The two needles are
- pushed through the cork to an equal length, and the ball bearing is placed in
- the tube. The test tube is corked and taped to a door handle. The wires are
- then connected from the eyes of the two needles to the battery, with one wire
- going via the blasting cap. Next, the battery and stick of dynamite are taped
- to the back of the door. When the handle is turned the ball bearing will roll
- and touch both of the needles, thus completing the electrical circuit and
- exploding the dynamite. The second door-handle trap is much the same, except
- it uses a mercury thermostat switch, rather than a ball bearing.
-
- CLOSEUP OF BALL BEARING AND MERCURY THERMOSTAT
-
- ############### ############### THEY SHOULD BOTH
- # ### ---##--- # # BE AT A SLIGHT SLANT.
- # ##### ## ---#=============#---
- # ### ---##--- #=============#
- ############## ###############
-
- They should both be at a slight angle so that the ball bearing is not touching
- both of the needles and the mercury is not touching both wires. And rember
- that most people that are normal turn the handle from the outside in a clock-
- wise motion so make sure you dont place the detonator backwards.
- ##############################################################################
- FLOOR BOARD TRAPS
- ##############################################################################
-
- The loose floorboard utilizes the same principles as the book trap , in
- that it relies on two metal contact points touching to complete the electrical
- circuit. Beneath the loose floorboard are two strips of pliable metal or
- bamboo, each with a metal contact point, which will touch when preasure is
- brought down on the loose floorboard.
-
- CLOSE UP OF LOOSE FLOORBOARD
-
- ########## ########## ########## ########## ########## LOOSE BOARD ##########
- #####################BAMBOO########################################
- ###################################################### =-----------
- ######################################################
- ###################################################### =-----------
- ###################################################################
-
- ##############################################################################
- ASSORTED DETONATORS
- ##############################################################################
-
- Well there are many kinds of detonators I will only discuss three in this
- file. Well there is the common fuse which is usually a black-powder core
- surronded with a fabric and then a layer of water resistent material. However
- there are many different types it can generally be said that safety fuses burn
- between 30 and 45 seconds a foot; however check these figures when you make
- your purchase. Bombs can be detonated in many ways the detonation and use of
- certain devices are based mainly on the cleverness and the imagination of the
- saboteur. Well the next detonation device I will discuss is the electrical
- detonator which requires either a solar igniter or just a thin wire. Well
- if you just have a piece of wire make sure it is all covered with plastic
- except for a small part about a half and inch or so. So when you connect the
- wire to the battery each side of the wire to each side of the battery. T the
- wire should get very hot depending on the size an amout of batteries you are
- using. Just the part where there is no covering should get the hottest and
- that is teh part that you will stick into the explosive. There are many ways
- you can use this so use your imagination. The next type of detonation device
- i will discuss is a nonelectrical blasting cap. You need a blasting cap for
- alot of the more powerful explosives like tnt. A blasting cap is a low
- explosive compound that is connected to a high explosive, for the purpose of
- detonating it,to use the nonelectrical blasting cap one gently pushes the fuse
- into the hollow end, until it is in fully. He then crimps the metal end
- around the fuse and puts it in the high explosive. When the fuse burns down
- it ignites the flash charge which in turn explodes the priming charge, which
- detonates the base charge, and finally creates enough heat to set off the high
- explosive charge. The fuse is an ordinary safety fuse which I already
- discussed or a detonating cord. When the fuse is put into the blasting cap,
- it is necessary to seal it. This act of sealing is called crimping. When
- involved with this sort of thing, one must use the standard precautions.
- Crimpers look like a pair of pliars, and there function is very similiar
- although pliers cannot be used for crimping. With the crimper in your right
- hand and the blasting cap in your left, slowly squeez the hollow end of the
- blasting cap, as this may detonate it.
-
- CLOSEUP OF BLASTING CAP
-
- -HOLLOW COPPER SHELL -FLASH CHARGE -PRIMARY CHARGE
- / / /
- ******************************************************************************
- !!!!!!!!!!!!@@@@@@@@@@@@###########*
- !!!!!!!!!!!!@@@@@@@@@@@@###########*
- !!!!!!!!!!!!@@@@@@@@@@@@###########*
- ******************************************************************************
- /
- BASE CHARGE-
-
-
-
- WELL THATS IT FOR NOW IF YOU HAVE ANY QUESTIONS OR SUGGESTIONS YOU CAN
- GET IN TOUCH WITH ME ON THE PALACE AE/CAT FUR/BBS [305]-[563]-[8930] AND
- BE SURE TO LOOK FOR MY NEXT FILE CALLED "BOMB TRAPS II". I GOT MOST OF THIS
- INFORMATION FROM THE BOOK "THE ANARCHIST COOKBOOK" AND FROM COMMON KNOWLEDGE.
- FEEL FREE TO PASS THIS FILE AROUND BUT, MAKE SURE YOU KEEP THE CREDITS INTACT
- OR THE BROTHERS OF THE EYE (B.O.T.E.), THE SILICON SLAVES, AND THE DOS BUSTERS
- WILL RAG YOU BIG TIME.
-
- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%